The Ford Barn - View Single Post

rockfla · 11-01-2015, 09:29 AM

All good advice here, the only thing I can ad from my experience is leaving as many bolts as you can loose till everything is in it hole. Then you can go back and tighten everything once its all lined up and all bolts are in the holes. I use a #6 X 3" or 4" taper pin to help line up holes and hold them in place while you install bolts on either side of the taper pin.

11-01-2015, 09:29 AM	#4
rockfla Senior Member Join Date: Mar 2014 Location: Jacksonville FL Posts: 3,953	Re: 1935 Front Sheet metal Fitment All good advice here, the only thing I can ad from my experience is leaving as many bolts as you can loose till everything is in it hole. Then you can go back and tighten everything once its all lined up and all bolts are in the holes. I use a #6 X 3" or 4" taper pin to help line up holes and hold them in place while you install bolts on either side of the taper pin.