Re: 55/56 Ford front bumper license plate holder
Reviving an old thread.
Using the picture from post 15 I made one for a lot less than what the repops are selling for.
First the pattern for the frame. I cut it from a piece of scrap heavy gauge steel left over from floor pan replacement. A couple of bends using a pair of pliers, a propane torch and a vice. Installed the front and rear bolts, did a couple of spot welds to hold them in place. Added a stainless frame from O'Reilly. Works for me.
__________________
'54 Skyliner. Restoration in progress.
|