View Single Post
Old 05-19-2014, 04:28 PM   #7
40cpe
Senior Member
 
40cpe's Avatar
 
Join Date: May 2010
Location: Star, MS
Posts: 3,678
Default Re: Old problem revisited, rough running 8BA

If I remember right, the first problem was because of bent rods in the carb and new ones were on order. At that time the idle was fine, and ran bad above idle. Bubba had checked your distributor to be fine. You have been tutored on how to time it. As already mentioned, verify good voltage to coil, Unless you have a new carb on it, I would look there.
40cpe is offline   Reply With Quote