View Single Post
Old 08-16-2020, 10:14 AM   #16
katy
Senior Member
 
katy's Avatar
 
Join Date: Jun 2015
Location: Alberta, Canada
Posts: 2,909
Default Re: measure gap between rotor and plug posts in distributor cap

Quote:
Make the gap 0.015" to 0.025" by gently /carefully bending the brass tab on the rotor
The rotors that I have have a steel, not brass, "tab", and methinks that trying to bend one would end up breaking the rotor.
The gaps between the rotor and the distributor body on my A are quite different from one terminal to another but the engine runs just fine that way.
__________________
Play it again Sam.
katy is offline   Reply With Quote