View Single Post
Old 08-15-2020, 08:38 PM   #12
Chuck Sea/Tac
Senior Member
 
Chuck Sea/Tac's Avatar
 
Join Date: May 2010
Location: Between Seattle & Tacoma
Posts: 2,029
Default Re: measure gap between rotor and plug posts in distributor cap

Quote:
Originally Posted by chrs1961815 View Post
What I have found is that too large a gap causes the engine to not run as well and backfire occasionally. A slight gap or the spring touching the carbon contact work fine.
Are you referencing the rotor spring and the carbon button on the cap? There should be no gap there, just a slight spring pressure as you push the top/cap down to lock it in place.
Chuck Sea/Tac is offline   Reply With Quote