Thread: radius rod ball
View Single Post
Old 05-27-2015, 09:48 PM   #8
Synchro909
Senior Member
 
Synchro909's Avatar
 
Join Date: Jun 2014
Location: Melbourne, Australia
Posts: 7,472
Default Re: radius rod ball

I haven't done this - Yet But I've wondered about tapping the hole in the casting and making a stepped stud to go in there. The bottom end would take the existing nuts. A wire through each stud will stop them coming undone. Maybe not right for a show car but for a driver, I think ir would be fine and much easier.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood.
Synchro909 is offline   Reply With Quote