The Ford Barn - View Single Post

rotorwrench · 02-01-2020, 07:00 PM

I wouldn't worry about the oil feed bores as much as whether it will clean up at .030" under. You can chamfer the oil ports a good bit and not hurt function at all.

02-01-2020, 07:00 PM	#7
rotorwrench Senior Member Join Date: Jun 2010 Location: San Antonio, Texas Posts: 16,440	Re: Is this junk I wouldn't worry about the oil feed bores as much as whether it will clean up at .030" under. You can chamfer the oil ports a good bit and not hurt function at all.