The Ford Barn - View Single Post

flatmotor40 · 05-13-2021, 05:20 AM

Thanks I've sprayed with WD 40 a few times a year.This is a Mallory electronic.And it get moisture in it with gasket on or off.Will try the drill but 1 more question is the other cap I keep for roadside repair it has no brass contact in the cap where the coil wire goes or it came out sometime.Just looked at it the other day and was going to put some dielectric grease in the holes for the wires and seen no brass contact.

05-13-2021, 05:20 AM	#12
flatmotor40 Senior Member Join Date: May 2010 Location: Georgia Posts: 611	Re: dist cap problems again Thanks I've sprayed with WD 40 a few times a year.This is a Mallory electronic.And it get moisture in it with gasket on or off.Will try the drill but 1 more question is the other cap I keep for roadside repair it has no brass contact in the cap where the coil wire goes or it came out sometime.Just looked at it the other day and was going to put some dielectric grease in the holes for the wires and seen no brass contact.