Re: Speed Bleeder
John R: Sorry, I don't think I'll be making any more of those due to the cost of water jet cutting and high cost of purchasing steel in small amounts. I advertised on Fordbarn and HAMB with minimal responses. Even sent an email to MT folks.
danliveshere: Those (RED) drum retainers will not fit the standard Ford backing plates and drums - only the MT Products drum and backing plate. If you have access to a MIG welder, some 1/8 inch steel, some metal files an electric drill and a hack saw you can make the ones shown below that I made in 2003. They do fit the standard Ford set up and are "beefier" than those being sold today.
Scott: Glad they worked for you. Thanks again.
Last edited by 19Fordy; 03-28-2017 at 08:13 AM.
|