The Ford Barn - View Single Post - Rear axle housing repair sleeves not hardened

barnstuf · 03-08-2019, 02:03 PM

In answer to BUD, #25 responder, I was told by a retiree friend, now deceased, who was an automotive engineer for General Motors, and ran a Hyatt bearing factory, that it was part of the General Motors family, so I doubt if it was an original equipment bearing supplier to Ford.

03-08-2019, 02:03 PM	#33
barnstuf Senior Member Join Date: May 2010 Location: Cape Cod MA Posts: 2,840	Re: Rear axle housing repair sleeves not hardened In answer to BUD, #25 responder, I was told by a retiree friend, now deceased, who was an automotive engineer for General Motors, and ran a Hyatt bearing factory, that it was part of the General Motors family, so I doubt if it was an original equipment bearing supplier to Ford.