View Single Post
Old 07-09-2020, 12:26 PM   #17
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
Default Re: Pressure plate finger adj

Quote:
Originally Posted by TomO View Post
Chart for pressure plate:
Clutch diameter Gauge Thickness Lever Height
9" clutch .340" 11/16" from top of plate
10" clutch .295" 15/16" from top of plate
11" clutch .365" 7/8" from top of plate


To measure place a straight edge across the top of the pressure plate and measure from the bottom of the straight edge to the top of the finger. The pressure plate should be installed on a flywheel with the spacer taking the place of the disc. A new or used disc should not be used instead of the spacer because it may not be uniform in thickness.
Thanks for the additional information Tom. I only had the specs for the 9".
__________________
"I can explain it for you. However, I can't understand it for you".
Kube is offline   Reply With Quote