View Single Post
Old 01-25-2020, 10:53 PM   #1
Jeff M
Senior Member
 
Join Date: Nov 2011
Location: CA
Posts: 104
Default Brake Light Switch Backwards

I installed a new harness recently and everything worked fine, but the rear brake lights stay on until I depress the pedal. The car is a '30 with two rear tail lights and I'm using a '28-'29 brake light switch.

I figured it might be a ground issue but the brake lights work just not correctly. I don't have the engine pans installed, maybe I need to run a ground strap from the bell housing bolt to frame? I did disassemble the brake switch and made sure everything was aligned prior.
Jeff M is offline   Reply With Quote