Quote:
Originally Posted by Thearne3
Perhaps a separate thread for uses of 3d printing? I use Fusion 360 for modeling and simple Anycubic 3D for printing - will print up to 10” cubic area. So far I’ve used it for three things for the A: the ‘Yoke’ piece in the vacuum wiper, bumper holder for LED signal lights (the ones sold by venders are WAY over priced!), and now this project.
|
I'd love it if there was a thread for 3D print models for devices for Model A's. Just a general thread where everyone could drop in whatever models they came up with or at least link to where they are stored.