View Single Post
Old 11-16-2019, 06:41 AM   #1
barrelnose
Junior Member
 
Join Date: Jul 2010
Location: Perth Hills Western Australia
Posts: 21
Default B model distributor question

Does the B model distributor/head use the same bolt on the side of the head to keep it held down?
I am trying to remove the distributor but there is no bolt in the side hole and it appears to be a blind hole. The Distributor is rusted badly and that may make it hard to remove,but this either has a broken bolt in the hole(its about a 1/4 deep) or it is a blind hole. I touched the bottom of the hole with a 5/16 drill and a appears to be soft like cast iron,not a broken bolt.
Any clues please.
barrelnose is offline   Reply With Quote