The Ford Barn - View Single Post - 3-brush gen problems

koates · 07-24-2021, 07:40 PM

Fun Projects are still in business, but dont sell direct to the public or to Macs anymore. You can buy them off C&G Ford parts in California. Make sure you order the correct voltage and NEG or POS ground type for your application. Set the third brush to a max of about 15 amps (have to rev her up a bit for this) with the regulator out of the circuit (not connected) and then connect the regulator. Regards, Kevin.

07-24-2021, 07:40 PM	#2
koates Senior Member Join Date: May 2010 Location: Melbourne Australia. Posts: 2,079	Re: 3-brush gen problems Fun Projects are still in business, but dont sell direct to the public or to Macs anymore. You can buy them off C&G Ford parts in California. Make sure you order the correct voltage and NEG or POS ground type for your application. Set the third brush to a max of about 15 amps (have to rev her up a bit for this) with the regulator out of the circuit (not connected) and then connect the regulator. Regards, Kevin.