The Ford Barn - View Single Post

Mike B · 09-29-2014, 10:17 PM

I get ya Jack.

Ya, had me scratching my head for a bit.

What's the worse that can happen?...loose a bit off coolant, and then fix it.

BTW, I've good luck (not on FH's) by drilling slowly, lil grease on the bit...yeah, I know, and a helper with a shop vac..same with tapping-sans vacuum, just grease and clean, repeat...if you have to go down that road.

09-29-2014, 10:17 PM	#7
Mike B Senior Member Join Date: May 2010 Location: Oakdale,Ca Posts: 1,323	Re: Replace two 3/8" head studs? Or not? I get ya Jack. Ya, had me scratching my head for a bit. What's the worse that can happen?...loose a bit off coolant, and then fix it. BTW, I've good luck (not on FH's) by drilling slowly, lil grease on the bit...yeah, I know, and a helper with a shop vac..same with tapping-sans vacuum, just grease and clean, repeat...if you have to go down that road.