The Ford Barn - View Single Post - media blasting

Mitch · 09-01-2010, 05:39 AM

No matter what blaster you use there are a few things you must have to have for it to work. One is a compressor big enough, say 18-20 cfm (that is 5 hp). Two is dry air, like with an oil seperator & dessicant dryer. Hose big enough, 0.5" or bigger and the shorter the better. The black diamond from Tractor supply is what we use because it is rather fine. We use the nozzle size just smaller than 1/8", about 40 psi. and back off from the panel to just remove paint, slowly. WE also use a fresh air system and ventilation similiar to a paint booth.

Now when you add up all the equipment and media. Without adding any value for you time. It's very economical to pay a qualified business to do the work. The big question is which business is qualified.

09-01-2010, 05:39 AM	#16
Mitch Senior Member Join Date: May 2010 Location: Dayton, Ohio Posts: 182	Re: media blasting - special considerations? No matter what blaster you use there are a few things you must have to have for it to work. One is a compressor big enough, say 18-20 cfm (that is 5 hp). Two is dry air, like with an oil seperator & dessicant dryer. Hose big enough, 0.5" or bigger and the shorter the better. The black diamond from Tractor supply is what we use because it is rather fine. We use the nozzle size just smaller than 1/8", about 40 psi. and back off from the panel to just remove paint, slowly. WE also use a fresh air system and ventilation similiar to a paint booth. Now when you add up all the equipment and media. Without adding any value for you time. It's very economical to pay a qualified business to do the work. The big question is which business is qualified.