Re: Need to re-torque head, but socket is too fat
I am always amazed to find "many" Model A guys that don't even torque those two long studs at proper torque. They are afraid of breaking the casting.
I believe they should be torqued the same as the others. I sand the mounting surface flat, use the proper copper/asbestos gasket or make a gasket out of a magazine cover. I have one ground down socket.
The distributor, Loosen the lock screw/nut, lift the distributor and torque. It's time to put a little grease or anti seize on the base of distributor so it doesn't rust anyway.
Richard
Anaheim CA
|