The Ford Barn - View Single Post

racer32 · 10-29-2014, 12:04 PM

Figured I'd pull this thread up to the top. I've been attempting to use my wire welder to remove some broken studs. Having a hard time keeping the nuts from just snapping off after I weld them on. Welder is Hobart 140 w/flux core. I'm about ready to give up, pull the engine, and put in small block Chevy. Any helpful hints?

10-29-2014, 12:04 PM	#15
racer32 Senior Member Join Date: Jul 2013 Posts: 149	Re: Broken head studs Figured I'd pull this thread up to the top. I've been attempting to use my wire welder to remove some broken studs. Having a hard time keeping the nuts from just snapping off after I weld them on. Welder is Hobart 140 w/flux core. I'm about ready to give up, pull the engine, and put in small block Chevy. Any helpful hints?