Quote:
Originally Posted by old ugly
i am disassembling a rear end assembly. i was going to pull the drive shaft out through the side of the banjo but driveshaft diameter will not allow the pinion bearing nuts to slide off. i am going to have to pull the pinion and driveshaft out through the front of the banjo. should not be a problem.
question. other than ratio, are all the pinions the same no matter what diameter the drive shaft is?
i am hoping this ring and pinion set will fit mine.
thanks
ou
|
Is this an early 32 rear end? They have a larger diameter drive shaft.
Tom Endy