The Ford Barn - View Single Post

old ugly · 10-12-2021, 10:02 PM

i am disassembling a rear end assembly. i was going to pull the drive shaft out through the side of the banjo but driveshaft diameter will not allow the pinion bearing nuts to slide off. i am going to have to pull the pinion and driveshaft out through the front of the banjo. should not be a problem.

question. other than ratio, are all the pinions the same no matter what diameter the drive shaft is?

i am hoping this ring and pinion set will fit mine.

thanks
ou

10-12-2021, 10:02 PM	#1
old ugly Senior Member Join Date: Aug 2021 Location: alberta canada Posts: 585	drive shaft diameter question i am disassembling a rear end assembly. i was going to pull the drive shaft out through the side of the banjo but driveshaft diameter will not allow the pinion bearing nuts to slide off. i am going to have to pull the pinion and driveshaft out through the front of the banjo. should not be a problem. question. other than ratio, are all the pinions the same no matter what diameter the drive shaft is? i am hoping this ring and pinion set will fit mine. thanks ou