Quote:
Originally Posted by Tim Ayers
Tubman,
I need to do this as well. Did you use a socket or piece of pipe as the die and block the back of the bearing to remove it from the hub? Then reverse it to install?
|
I'm sure I did, but it was a couple of years ago so I don't remember exactly. It had to be pretty simple, because if it would have been difficult to any degree, I'm sure I'd remember what I did. One thing I can tell you is that I have a 3/4" drive socket set that gets used more for dies and spacers than it does for nuts and bolts.
I do remember that it didn't take much force at all to move it.