Thread: ID this part?
View Single Post
Old 07-07-2020, 10:15 AM   #3
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 6,339
Default Re: ID this part?

Will N could be right on carb type or could be NH. Not a stock item, home made. Might have been used on stationary power unit. Too long for car setup. The U-joint would have been down at the needle end.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote