The Ford Barn - View Single Post

CT Jack · 01-31-2017, 10:58 PM

I have to ask Dave from MN a question. Is it possible the machinist preparing the block for the inserts didn't install the proper dimensions for a good fit for the OD of the inserts?Taking this possibility into consideration along with a tight bearing fit initially and also maybe the engine wasn't dynamically balanced properly could have all contributed to the failure. If this did happen it had nothing to do with the inserts.

01-31-2017, 10:58 PM	#11
CT Jack Senior Member Join Date: May 2010 Location: Hebron, CT Posts: 432	Re: Insert bearings I have to ask Dave from MN a question. Is it possible the machinist preparing the block for the inserts didn't install the proper dimensions for a good fit for the OD of the inserts?Taking this possibility into consideration along with a tight bearing fit initially and also maybe the engine wasn't dynamically balanced properly could have all contributed to the failure. If this did happen it had nothing to do with the inserts.