Ford Folks,
Pretty quiet on the 32 progress.
Will work with Valley Machine to get the specs for the engine and dimension and then Snyder's for the proposed parts required. That may take a week or so.
A good friend John R stopped by and brought me some spare parts he had. Great to have good friends in Ford places! The intake manifold looks like it would work fine if needed. The water pumps and fuel pump are from something else.
I had to climb in the cab yesterday for a couple minutes. John said he might have a turn signal switch like mine.
Yes the 70+ year old cloth electrical tape is still there too!
No clue about the wiper motor?
Making some progress in the shop on the wall coverings: Cutting to length, sanding, coating, re coating, installing. Its going to look pretty good.
The small room in the corner is for a vertical air compressor. Thinking of getting a 80 gallon and leaving the 60 gallon Kobalt, in the house garage. The small room is to insulate some noise. Still have to drill the vent holes in the lower steel for air inlet.
Regards,
Chris