Re: Crank pulley bolt...Lost again!!
I don't think the distance from front of hub to end of crank is a problem as long as it's sitting properly on the machined register of the pulley and crank.
Your washer is THICK, right? Like 3/8" or so?
Joe Abbin recommends 130-145# of torque on the crank bolt, and that sounds about right.
Terry
__________________
"It don't take but country smarts to solve the problem" (Smokey Yunick)
'41 Merc Town Sedan / 260" 8CM engine
'66 Fairlane four door / "warmed up" 302
|