View Single Post
Old 09-08-2020, 12:12 PM   #9
patmanta
Junior Member
 
Join Date: May 2013
Location: Woburn, MA
Posts: 19
Default Re: EAB Heads & their Piston Reliefs - Is this right?

Quote:
Originally Posted by rotorwrench View Post
A lot of those type sellers don't care if they mill the same amount or not. I've seen it happen before. One head had been milled so far that it had material removed from the bottom of the thermostat pocket area (8BA heads).
I am really bummed out about this but I bought them 5 years ago on eBay and really should have asked more questions about what was done to them and looked closer. At the time it didn't even occur to me that these would have been milled improperly or for a specific block.
patmanta is offline   Reply With Quote