View Single Post
Old 06-27-2020, 11:52 AM   #5
Senior Member
Jim/GA's Avatar
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,612
Default Re: Firewall Insulation

Originally Posted by Conaway2 View Post
How does the molded panel attach to the firewall ?
They give you longer versions of all of the screws that go into the firewall from the inside. You replace existing with longer ones through panel. I also put longer screws in mine going from the engine side, then put nut/washer on them inside. They also have small brackets in the upper left/right corners that hold those corners in.

It's pretty stiff molded plastic, so it does not take a lot to keep it up there.

Jim Cannon
"Have a Model A day!"
  • Repair
  • Restore
  • Drive
  • Enjoy!
  • Join MAFCA
Jim/GA is offline   Reply With Quote