View Single Post
Old 07-29-2013, 04:39 PM   #23
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 9,737
Default Re: Success with improvements for touring

Quote:
Originally Posted by quickchange View Post
So where do we find these 3.27 original ring & pinnion sets from ? I have had 56 Model A,s & non had 3.27 rears . Are these a MODERN UP GRADE like the tele shocks etc or did some A,s come out factory with them ?? IF not then this must be a modification too.

This thread has been "twisted" WAY off-topic but going to back to the first comment, I believe the point was we should consider putting on tube shocks, an electronic ignition, and an overdrive because it is easier on the car & driver if we plan to tour with our Model-As.


To play Devil's Advocate with your question, can you walk up to any Model-A and at a glance tell what rear end gear ratio it has installed?
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote