The Ford Barn - View Single Post

OLD AS I · 02-10-2017, 06:55 AM

Hello Gear Rat
I just went through this, well ,just about through it, am assembling my distributer this week end, based on what I've learned here on the Barn Bubbas the only way to go, see my posting on here, " '46 Crab distributor/wire assy " lots of comments there, I tried using a plug wire set from Bob Drake, was the one he lists for '46, its plastic coated and WILL NOT fit inside the 2 piece cap, that's $45. US down the drain. Am going to use Packard Delco wire, am sure it will work PM me if we can share info

02-10-2017, 06:55 AM	#4
OLD AS I Senior Member Join Date: Oct 2014 Location: Oakwood, ON Canada Posts: 251	Re: Crab style distributor? Hello Gear Rat I just went through this, well ,just about through it, am assembling my distributer this week end, based on what I've learned here on the Barn Bubbas the only way to go, see my posting on here, " '46 Crab distributor/wire assy " lots of comments there, I tried using a plug wire set from Bob Drake, was the one he lists for '46, its plastic coated and WILL NOT fit inside the 2 piece cap, that's $45. US down the drain. Am going to use Packard Delco wire, am sure it will work PM me if we can share info