Re: “Inside” part of road draft tube
Hey Merc!
What if I cut a 3/8” or so 1/2” deep slot between the two holes where the carb would go (which now has a block off plate)to join the left and right plenum. The left and right plenums are currently separated completely under the carbs..... this would join the plenums under the block off plate. I would then need only one vacuum fitting to run to the pcv valve?? I could just enlarge the hole/fitting to 3/8” that I currently have in my block off plate. This is all a question!
I can be dangerous and screw up a lot of parts given too much time to think!!!!!
|