View Single Post
Old 02-28-2018, 01:12 PM   #7
Kevin in NJ
Senior Member
 
Join Date: May 2010
Location: South East NJ
Posts: 3,398
Default Re: Engine quit ------ Condenser overheated

Go over to the Mustang boards and you will find guys complaining about the new caps. They are sourced from china and the QC is not so good, this is for even the 'better' brands.

Get the A&L where they spend the extra bit of money for a better rated cap and they don't seem to fail.

As for the points. Original plates that are not worn are likely a better fit then new. Depends on a few factors and will affect point gap as you move the plate. It is likely that a quality set of used original points will give you decades of use. Just make sure you use a good wire between the lower and upper plates.

Basically, original done right with a A&L cap is likely to be basically trouble free (occasional adjustment and correct lube) for as long as you own the car.
Kevin in NJ is offline   Reply With Quote