View Single Post
Old 09-06-2021, 05:26 PM   #16
KULTULZ
Senior Member
 
KULTULZ's Avatar
 
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
Unhappy Re: preferred 2 barrel Y-block intake manifold?

Quote:
The 56 truck in one of those has a 302, and it probably has side motor mounts added. They may have something in the kit that adds those back for the trucks.
I never understood that MICKEY MOUSE setup on either the F-SERIES or especially the BIRD. Holding down an F-CODE with ski poles ain't too smart.

Any-who, the 56 F100 swap shown has a base 302 and an engine mount conversion kit installed if you look closely. The author stated that there was very little power with the 302 so most likely a 239 2V (especially LOAD-O-MATIC) ain't gonna cut it on the highway.

This is one of those projects that keeps snow balling, especially if not hawked out and strategized properly.

Wait and see what the OP says ...
__________________
*****

We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ...
KULTULZ is offline   Reply With Quote