Re: Wheel Washers
Keith, below are pictures of my left side. Are the studs swedged on it?
Mercman, thank you for the nice picture enlargements, do you see something else I might be missing?
It is obvious that the right side with the incorrect studs needs to go. What would be the best thing to do? Replace the studs with the correct ones? Buy a new drum and hub with the studs already installed? Look for something on the used market? I also noticed that the two rear drums are somewhat different. Should that create a problem?
Sorry for rambling on. I also need to decide if I should shim the axles, or just add another washer to make the split pin line up properly with the axle nut.
Thanks again for everyone's help.
Tom L.
|