Re: What do you regret?
I was told that the A motor that I had bought had recently been rebuilt. I rebuilt that A motor with all new valves, springs, guides, 0.040" over rings, etc. It didn't have a ring wear ridge in the cylinders so I assumed from what I was told by the seller, that the cylinder bore didn't have much wear and it was straight. So I didn't measure the cylinder taper. Wrong move... I found out when I started the engine up that the cylinders had too much taper and when cold, the pistons were slapping the walls. The block needed all four cylinders re-bored. What a waste of parts and time! Don't assume anything.
|