The Ford Barn - View Single Post

Terry,OH · 07-11-2016, 06:30 AM

It does not have brackets just screws (I believe: trim washers for the screws on the bottom) holding the header to the inner structure. The original holes should still be in place unless they were filled during restoration. Most of the originals I have seen are black paint finish. The metal header gets covered with headliner material and installed after the rest of the headliner. This allows access to the wiper motor. Yes there are two holes for the two wiper motor control knobs. Is the SAR panel without the factory holes?

07-11-2016, 06:30 AM	#7
Terry,OH Senior Member Join Date: May 2010 Posts: 4,751	Re: 1934 ford windshield header panel It does not have brackets just screws (I believe: trim washers for the screws on the bottom) holding the header to the inner structure. The original holes should still be in place unless they were filled during restoration. Most of the originals I have seen are black paint finish. The metal header gets covered with headliner material and installed after the rest of the headliner. This allows access to the wiper motor. Yes there are two holes for the two wiper motor control knobs. Is the SAR panel without the factory holes?