The Ford Barn - View Single Post

WHN · 07-20-2020, 11:34 AM

Similar problem when we put front end back together after rebuilding.

We were using a different wishbone. The original one was worn and bent where it mounted to front axel on drivers side.

Well problem was axel also had a very slight bend. Most likely car was hit years ago on drivers side front wheel.

Fixed axel problem, everything fit fine.

Enjoy.

07-20-2020, 11:34 AM	#5
WHN Senior Member Join Date: Mar 2017 Location: Connecticut Shoreline Posts: 1,823	Re: Frame to front and rear end alignment Similar problem when we put front end back together after rebuilding. We were using a different wishbone. The original one was worn and bent where it mounted to front axel on drivers side. Well problem was axel also had a very slight bend. Most likely car was hit years ago on drivers side front wheel. Fixed axel problem, everything fit fine. Enjoy.