The Ford Barn - View Single Post - 64 Galaxie removing ignition lock cylinder

callbald · 08-07-2020, 01:59 PM

The instruction are simple BUTTTT the key cylinder will not come out. Just turn the key to acc and insert a paper clip size wire in the pin hole and turn counter clock wise more and pull it out. Well it comes out about 1/8 inch and that is it.

I am replacing both lock cylinder and ignition switch. Maybe drill until it comes out. Any suggestions????

08-07-2020, 01:59 PM	#1
callbald Senior Member Join Date: Jan 2014 Location: Leo, Indiana Posts: 235	64 Galaxie removing ignition lock cylinder The instruction are simple BUTTTT the key cylinder will not come out. Just turn the key to acc and insert a paper clip size wire in the pin hole and turn counter clock wise more and pull it out. Well it comes out about 1/8 inch and that is it. I am replacing both lock cylinder and ignition switch. Maybe drill until it comes out. Any suggestions????