Quote:
Originally Posted by Richard in Anaheim CA
Has anyone had any experience milling the Snyder 6.0 head for more compression?
How did you mill it and what would you guess the compression is?
Richard
Anaheim CA
|
Since no one else has responded, I will say this. Yes, I resurface each 6:1 head I install, -but to your question, not to necessarily increase compression. I resurface them to obtain a better surface finish, and to ensure the deck is truly flat. As for compression, I can cc it for you but in all likelihood you would only see a marginal increase of probably less than 0:1.