The Ford Barn - View Single Post

GeneBob · 03-21-2021, 10:22 PM

I would like to build one of these.
Jim Brierley, I was thinking of going with a Bill Stipe oil pump to ensure sufficient oil volume to run an oil filter with full pressure to the bearings.
Carl, as far as the head, after building this engine up, I would want to run the best performance head I could afford.

03-21-2021, 10:22 PM	#5
GeneBob Senior Member Join Date: May 2017 Location: Denver Area Posts: 433	Re: The new Burtz Mosel A engine I would like to build one of these. Jim Brierley, I was thinking of going with a Bill Stipe oil pump to ensure sufficient oil volume to run an oil filter with full pressure to the bearings. Carl, as far as the head, after building this engine up, I would want to run the best performance head I could afford.