Quote:
Originally Posted by LP
I have recently purchased a 53 Ford Customline 4door with Flathead V8 3 speed.
I replaced the master cylinder and wheel cylinders.When I put the fittings back on the front of the master cylinder it leaks between the washer and master cylinder and between fitting.
I did not have new washers or the fitting itself. I know I have the parts in the proper order. Any help would be appreciated
|
You can anneal the copper washer/s and re-use.
Heat the washer/s to red hot and immediately quench in cold water.
It may or may not do the trick but it has for me at various times.