Thread: New Zenith Carb
View Single Post
Old 08-02-2010, 10:36 PM   #7
Mike V. Florida
Senior Member
 
Mike V. Florida's Avatar
 
Join Date: May 2010
Location: South Florida
Posts: 14,054
Send a message via AIM to Mike V. Florida
Default Re: New Zenith Carb

Quote:
Originally Posted by Domino View Post
I am in need of another carb for the tudor (runs great withthe carb off another A) and am debating whether to put a kit in the tilly or purchase another carborator. The one shown below is under consideration. Has anyone purchased one of these and is willing to share their feelings about it? It's for a driver so appearance is not of importance to me.

As always - thanks in advance.

Frankenstein has risen from the Old fordbarn to once again pit purists against drivers.

I have the link to the old Fordbarn but I won't post it.

To sum up what was said in the old post, The new carb does work with the A. Many stated that it worked better then the one on their car.

Others noted that dyno test showed that these produced less horsepower then original properly rebuilt Carbs. It was also noted that the cost to have the original carb built by an experienced rebuilder is about the same as this carb.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II

Last edited by Mike V. Florida; 08-03-2010 at 12:01 AM.
Mike V. Florida is offline   Reply With Quote