The Ford Barn - View Single Post

whb52ford · 11-20-2021, 09:42 AM

At the relay, if I ground the relay, the relay clicks, but not the solenoid. When the relay clicks, it should engage the solenoid. Have not taken the cover off the relay again, but I'm positive I will see the contacts in the relay closing, yet it is not sending power to the relay. If I go from power on relay to solenoid it clicks, so the solenoid is good. I just don't know why that relay does not send power when the points are closed.

11-20-2021, 09:42 AM	#15
whb52ford Senior Member Join Date: Jan 2013 Location: Ocala, FL 34481 Posts: 235	Re: BW R10 governor At the relay, if I ground the relay, the relay clicks, but not the solenoid. When the relay clicks, it should engage the solenoid. Have not taken the cover off the relay again, but I'm positive I will see the contacts in the relay closing, yet it is not sending power to the relay. If I go from power on relay to solenoid it clicks, so the solenoid is good. I just don't know why that relay does not send power when the points are closed.