Re: Decided to pull the motor/trans
Quote:
I can't think of any way that a cylinder can wear that much and not leave a ridge.
|
Model T's do that, the top ring comes right to the top of the cylinder w/the piston sticking up above the block. Maybe the pistons you removed are like that?
Quote:
I already removed the taper and brought the cylinders to 4" (the pistons mic 3.998). well, 3 are done, one to go.
|
Is .002" piston clearance enough on these engines?
__________________
If you don't hear a rumor by 10 AM, start one!.
Got my education out behind the barn!
Last edited by katy; 07-26-2020 at 09:49 AM.
Reason: Corrected typo
|