[fordson]

Hello barners,
I have found a good 1933 Ford dash insert gauge panel. Unfortunately the chrome has peeled off and the engine turned swivel pattern with it. I would like to restore the panel to its original former glory, avoiding a remanufactured billet repro panel. I have not found any information on the 1933 gauge panel manufacturing process with regards to the finish.
From what i have seen, the gauge panel is steel and must have been chromed initially. The engine turned swirl pattern must therefore have been applied by hand onto the chromed surface. I read that for the engine-turning pattern a 1/2” abrasive rubber stick is beeing used.

I would appreciate any information on the process and steps on how this gauge panels finish was produced, including the size / diameter and spacing of the swivels.
Any information with regards to someone who can or still does the engine turned swivel on chrom is much appreciated.

Thank you for your help,
many regards