Hello
I'm new to the barn and just started a A project.
I dismantled the for at least 25 Years sleeping engine.
Head pulled.jpg Two oil rings where broken and one compression ring has gone during the removing. After cleaning (the cylinder surfaces felt smooth again) I mesured the cylinder an piston diamters.
Engine bore mesurements.jpg
With my simple understanding I'm not sure which oversized pistons are in. Should be the 0.06 in, right?
What treatment would be recommended in this case? Could a new honing and new ring sets work out or is a borint to the next oversized piston diameter a must?
Engine bore original and play.jpg
Btw is the piston play of 0.002 in to 0.007 in correct?
Thanks a lot for any reply