The Ford Barn - View Single Post

SAJ · 05-12-2020, 05:04 AM

Werner, you have a typo there. 0.004 or 4 thou is far too much for a wrist pin.
0.01 mm is correct. A firm push fit. And a honed finish after reaming is best in my view.
SAJ in NZ

05-12-2020, 05:04 AM	#35
SAJ Senior Member Join Date: Jul 2010 Location: Auckland, New Zealand Posts: 515	Re: Bad rod bearing Werner, you have a typo there. 0.004 or 4 thou is far too much for a wrist pin. 0.01 mm is correct. A firm push fit. And a honed finish after reaming is best in my view. SAJ in NZ