Re: rebuilding model a shocks
I used to build them......few things
A. Start with something that has a fighting chance of being a viable shock after rebuilding.
Off center shocks and those that open up full of rust won’t do it.
B. Get them apart. Often heat is required. It is good to have a heavy strap wrench and
spanner wrench for lock ring.
C. Makes mounting jig for the shock body. A lot of pressure is often required to get the
covers and lock ring off
D. Don’t mix parts. Put all the same parts back to that shock
E. When apart clean thoroughly. There are two vent plugs in the reservoir cover inside.
Tap those out clean veins and replace.
F. Assemble and fill
I’m sure this is far from complete. Getting past A &B will be a challenge!
Last edited by Oldbluoval; 10-14-2020 at 04:44 PM.
|