View Single Post
Old 12-24-2010, 06:59 AM   #7
sturgis 39
Senior Member
 
Join Date: Aug 2010
Location: Lead. South Dakota
Posts: 963
Default Re: Gordon Smith question

Quote:
Originally Posted by old splicer View Post
Got all 14 nuts sitting on the bench, undid the two bolts above the water inlet and removed center section of the head. Took a chipping knife and inserted all the way around the perimeter into the gasket with no resistance until the front half of the head. at that point it feels like the head is still bolted on. Made up an adaper out of a spark plug and used a slide hammer to try to pop it up, great work out. but no movement. I'm begining to favor a cap and a little C4. might unfreeze the motor too!
Be sure to use delayed caps and use the original firing order of the engine.
__________________
IF IT CAN NOT BE FIXED WITH BLASTING WIRE, JB WELD OR DUCT TAPE ---IT CAN NOT BE FIXED

Do not get me started on the stupidity of ethanol. I think one of the monitors is from Iowa and he will delete the thread.
sturgis 39 is offline   Reply With Quote