Quote:
Originally Posted by DBSHELTON
Not sure about yours but my water outlet is plenty thick enough to drill and tap for a pipe thread. I have done several and none have leaked.
|
Ditto, especially if you were to braze (or even solder) the fitting into the neck.
BTW, I HATE those necks sold with a tapped hole already in them. What gives with putting the hole on the LHS of the neck where it makes access to the head stud not difficult. I have only ever bought one of them and it was so poorly made that I couldn't get the nut on the head stud for poor machining. Leave them on the vendor's shelf.